Conveyor belt use method:
输送带使用方法：
1, prevent the conveyor belt load start.
1、防止输送带负荷启动。
2, the conveyor belt deviation, should take timely measures to correct.
2、输送带发生跑偏，应及时采取措施纠正。
3, different types, specifications of the number of layers of conveyor belts should not be used together, the joint is best to use bonding method.
3、不同类型、规格层数的输送带不宜接在一起使用，其接头***好采用胶接法。
4, the type of conveyor belt, structure, specifications, layers should be reasonably selected according to the conditions of use.
4、输送带的类型、结构、规格、层数应根据使用条件合理选用。
5, the conveyor belt running speed should not be greater than 2.5m/s, large block, wear of large materials and the use of fixed pear discharge device should be as low as possible.
5、输送带运行速度一般不宜大于2.5m/s，块度大，磨损性大的物料和使用固定梨的卸料装置应尽量采用低速。
6. The relationship between the diameter of the transmission drum of the roller conveyor and the distribution layer of the conveyor belt, the matching of the transmission drum and the reversing drum, and the requirements for the groove Angle of the roller should be reasonably selected according to the design regulations of the conveyor.
6、滚筒输送机的传动滚筒直径与输送带布层的关系、传动滚筒、改向滚筒的配套以及对托辊槽角的要求应根据运输机的设计规定,合理选取。
7. The feeding direction should follow the running direction of the conveyor belt. In order to reduce the impact of the material falling on the conveyor belt, the chute should be adopted to reduce the material drop distance;
7、给料方向应顺输送带的运行方向，为减小物料下落时对输送带的冲击应采溜槽，减小物料落差距离；
In the receiving section of the conveyor belt, the distance between rollers should be shortened and the buffer rollers should be used for material leakage. The conveyor belt should conform to the soft and moderate baffle plate, so as to avoid the baffle plate being too hard and scraping the belt surface.
输送带受料段，应缩短托辊间距和采用缓冲托辊为漏料，输送带顺应采用柔软适度的挡料板，以免档料板过硬，刮破输送带的带面。
8. When the conveyor is in use, if there is a lack of rollers, it should be added and repaired in time;
8、输送机在使用时，如有托辊缺少，应及时添加及修好；
The roller is covered by the material, resulting in poor rotation, to prevent leakage stuck between the roller and the tape, pay attention to the lubrication of the moving part of the conveyor belt, but do not oil the conveyor belt.
托辊被物料覆盖，造成回转不灵，防止漏料卡于滚筒与胶带之间，注意输送带活动部分的润滑，但不得油污输送带。
9, to avoid the conveyor belt by the frame, pillar or block material block, prevent breakage and tear, found that the conveyor belt local damage, the application of rayon cotton repair in time to avoid expansion.
9、避免输送带遭受机架，支柱或块状物料的阻滞，防止碰破扯裂，发现输送带局部破损时，应用人造棉及时修补，以免扩大。
