Reasons for belt conveyor belt deviation:
皮带输送带跑偏的原因：
1, the end of the barrel, the middle roller support in the installation process is not on the same axis, and not parallel.
1、首尾滚桶、正中间托辊支架在安装过程中没有在同一个轴线上，且不平行面。
Note: Check the horizontal center of the idler support and the vertical axis of the belt conveyor is inconsistent, and adjust.
提示：进行检查托辊支架横向中心与带式输送机纵轴不一致，并进行调整。
② Check the indicating error of two planes of needle roller bearings in the same plane.
②进行检查滚针轴承两个平面在同一平面内的示值误差。
2. The material on the belt conveyor belt is not kept in the central position, and the force is not uniform.
2、皮带输送带上的物料未保持在中心位置，受力不均匀。
Tip: Check the blanking position, increase the baffle, buffer the blanking speed, change the blanking direction and position.
提示：进行检查落料位置，增加挡板，缓冲落料速度，改变落料方向和位置。
3. There are unknown objects in the belt conveyor belt and the barrel.
3、皮带输送带与滚桶之中有不明物。
Tip: Keep belt conveyor belt and drum clean, keep clean, no unidentified objects.
提示：保持皮带输送带和滚桶清洁，保持清洁，无不明物。
